ORAFOL ORAGUARD 250AS Luster 4.75 Mil



NOTE: 50 yd orders contain two 25 yd rolls

  • 4.75 mil luster finish textured vinyl floor overlaminate
  • Protective laminate with high resistance to skidding and abrasion
  • Cold Overlaminate
  • Reverse Wound with liner side facing out to prevent scratching of the laminate surface
  • 3 month indoor durability for graphic floors
  • ASTM C1028 tested for slip resistance

Products listed on this page can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer, and toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

Floor Graphics

"Some customers extend the laminate ½" to 1" over the print to ensure adhesion to the floor. To do this, simply die cut the graphic and laminate it. Then hand cut or die cut the laminate at a larger size. It is critical to test your vinyl adhesion and its effect on the surface below. Especially if your customer is planning on removing the vinyl floor graphics later on. For example, some wood varnishes (like on a basketball court) may come up with the vinyl at removal time."


Sorry, there were no results for “{{ searchstring }}”