ScrapeRite Plastic Razor Blades and Scrapers




    Email us your photos to


NOTE: 50 yd orders contain two 25 yd rolls

Plastic Razor Blades

  • Designed to aid in the removal of pressure sensitive materials from metal, paint, plastic and glass surfaces that could be easily scratched  
  • Orange blade is standard-duty, Black blade is heavy-duty, more rigid and resistant to breakage and wear
  • Double-edged plastic blade that fits the Big Gripper and Little Gripper as well as most standard razor blade holders
  • Sealed pack of 100 Double-Edged Blades
  • Size 3/4" x 1 1/2 


  • The Big Gripper polycarbonate handle for the ScrapeRite® double edge plastic razor blades that fits comfortably in the palm of your hand and reduces fatigue
  • Slim lightweight profile stores easily in most common tool pouches.
  • Accommodates all ScrapeRite® plastic razor blades
  • 1 ¾” wide x 6” length x ¼” thick



  • The Little Gripper provides a holder for the ScrapeRite® plastic razor blades acting as a device to ensure easier use, it increases leverage and accuracy for the user.
  • The size allows for easy access into tight spaces and corners.
  • Accommodates all ScrapeRite® plastic razor blades
  • 1 ½” wide x 2” length x ¼” thick


Use Care Removing Vinyl from Glass

"Normal vinyl removal techniques are not generally appropriate when removing frosted vinyl from glass. Applying heat can cause the glass to crack or shatter. Using a solution of water and dish soap, saturate the vinyl with a fine mist, then cover with bubble wrap or plastic for two hours to prevent drying. The mixture of soap and water will penetrate through the vinyl and make removal much easier, without using heat."

Most Wrap Installers Use Heat

"Whether you use a torch or a heat gun on your wraps, heat is an important part of any wrap. Heat can be used to make pressure sensitive vinyl conformable around curves, rivets, and other irregular surfaces. Post heat is also a critical step when doing vehicle wraps to help "set" the vinyl. Direct heat should especially be applied to areas where the vinyl has been stretched. Slowly move the heat source across these areas until the Mastercool Infrared Temperature Gun reads no more than 200 degrees Fahrenheit (most manufacturers recommend not heating vinyl beyond 200 degrees), then move the heat source approximately one inch every two to three seconds. This technique relaxes the stress on the vinyl caused by stretching, which will help prevent lifting and tenting. Finally, heat is often used to remove a wrap, especially in cold environments. Heat allows the vinyl to come off faster and improves the ability to remove the adhesive with the vinyl instead of leaving adhesive on the surface which would require even more labor to remove."

WARNING: Do not use heat sources near gas tanks or flammable substance

ScrapeRite Testimonial

"I feel safe knowing that I can remove the biggest adhesive stuck to the vehicle without ruining the paint beneath. These scraperite tools are a must have for any custom automotive shop. It makes it easy to remove a basic sticker stuck to a window or an old racing stripe!"

Nick Turner
Apex Customs
Phoenix, AZ



Sorry, there were no results for “{{ searchstring }}”