3M™ IJ67 60/40

  • 3MIJ6(6 or 7)(SIZE)

    3MIJ6(6 or 7)(SIZE)


    Email us your photos to Gallery@fellers.com


NOTE: 50 yd orders contain two 25 yd rolls


  • 6 mil Scotchcal perforated window graphic film with clear removable adhesive 
  • 40% perforated pattern, 1.6mm hole size
  • Good for short-term retail and non-regulated vehicle and bus windows
  • Up to 1 year expected performance life
  • Polycoated paper release liner with continuous paper backing layer
  • Print compatibility: Solvent, Eco-Solvent, UV, Latex and Screen Print
  • For profiles: 3M Graphic Solutions - Color / ICC Profiles

Products listed on this page can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer, and toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

Putting the finishing touch on your vehicle wrap

"If you're looking for the ultimate finishing touch for a vehicle wrap, don't forget to print window perf with your killer design and install over the headlights and tail lights. It looks cool on, and doesn't alter brightness levels too much when the lights are on. Be sure to check the laws for your state before applying."

What's The Difference Between Perforation Patterns?




Should You Overlaminate Window Perf?

"If you want optimal protection for fading and scuff resistance then you must use optically clear vinyl overlaminate. However, if you want the utmost visibility through the perforated window film, then you can't vinyl overlaminate. In this case an aerosol spray overlaminate could be used prior to install and make sure that liquid does not plug up the perforations. Please note that if you do NOT use vinyl overlaminate it is very difficult to see through the perforated window vinyl when driving in the rain.

Do NOT Use Windex Before Wrapping!

"Ammonia based products, such as Windex, prevent the adhesive in window mounting adhesives from sticking to the glass. Instead use soap water, Rapid Prep, or alcohol to prep the surface."

Is The Glass Ready To Wrap?

"When installing window perf or other vinyl, many glass surfaces have wax or other invisible coatings on them (like RainX) that interfere with adhesion. Place several drops of water on the glass, if the water forms into beads there is a coating that must be removed. If the water does not form into beads there is no coating and you can proceed to clean with isopropyl alcohol."


Sorry, there were no results for “{{ searchstring }}”