Avery Dennison MPI 2902 3.2 Mil 4yr

  • A290254150

    A290254150

    GALLERY

    Email us your photos to Gallery@fellers.com
    SELECTED

    Products listed on this page can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer, and toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

ADD TO CART


PRODUCT DETAILS

NOTE: 50 yd orders contain two 25 yd rolls

  • 3.2 Mil calendered gloss white inkjet vinyl with removable grey opaque adhesive and clean removability up to 1 year
  • Great for POP, Wall Murals, Floor Graphics, general signage and banners
  • 4 year outdoor durability when laminated
  • Polyethylene coated 90lb StaFlat® liner
  • Combine with DOL 2000 or DOL 3000 series for cost effective floor graphics laminates
  • Formerly 3101
  • Caution:  Always pre-test vinyl installation on vehicles.  Do not install if there is any adverse or negative impact on sensors and/or other safety-related equipment on the intended vehicle
  • Print Compatibility: Solvent, Eco-Solvent, UV, Latex and Screen Print
  • For profiles, go to : http://avery-us.color-base.com/add_system.php



Floor Graphics

"Some customers extend the laminate ½" to 1" over the print to ensure adhesion to the floor. To do this, simply die cut the graphic and laminate it. Then hand cut or die cut the laminate at a larger size. It is critical to test your vinyl adhesion and its effect on the surface below. Especially if your customer is planning on removing the vinyl floor graphics later on. For example, some wood varnishes (like on a basketball court) may come up with the vinyl at removal time."

close

Sorry, there were no results for “{{ searchstring }}”