Magnum DigiMaxx 48" Super Wide Roll

  • DIGIMAXXSOL(20 or 30)MIL25

    DIGIMAXXSOL(20 or 30)MIL25


    Email us your photos to

    Products listed on this page can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer, and toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to



NOTE: 50 yd orders contain two 25 yd rolls


  • Superb ink adhesion and image quality
  • Runs smoothly and evenly on UV flatbed and other wide-format printers
  • Available in 20 mil or 30 mil matte white
  • Magnetized to 14 poles per inch
  • Can be cut, perforated or die cut
  • Great for retail signs, POP, menuboards, vehicle signage and more
  • Made in the USA
  • Print compatibility: Solvent, Eco-Solvent, and UV
  • Please refer to the Cleaning and Care Information Sheet for this product
  • When using 30 Mil for vehicle applications, please note please note: Must be removed and cleaned daily. 20 Mil is not recommended for vehicle applications. 

Preparation For Your Magnet

"Make sure the area of your car where you want to place the magnet is fairly flat or has only a mild curve, and that the entire surface is metal. If some areas are plastic or fiberglass, gaps can form, allowing wind to get under your magnetic sign and pull it off. Even new cars sometimes have unreported fiberglass repairs to metal surfaces. Therefore, it is important to test the entire surface for proper magnetic adhesion."

Why Should You Round the Corners of Magnetic Blanks?

"Our customers report that the first place that usually starts a problem for adherence of a magnetic sign to a vehicle, is the corners. Over time the corners may "flag up" creating the possibility for air and water to get underneath therefore causing the magnetic to not adhere well. Rounding the corners should help prevent this problem"


Sorry, there were no results for “{{ searchstring }}”