Car-Safe 40" Wide Roll



NOTE: 50 yd orders contain two 25 yd rolls

  • Greater yield for vehicle signage and wide format printing
  • 30 mil matte white magnetic
  • 12.5 PPI
  • Solvent ink compatible, confirmed use with Mutoh Valujet, Mimaki JV3, and Roland SC 540 EX will not work in the Versacamm (too thick to fit under printhead)
  • Caution: Confirm both printer & ink compatibility before full use of product
  • Profiles available for download here
  • Not compatible with HP Latex printers
  • Please refer to the Cleaning and Care Information Sheet for this product
  • For Vehicle Application please note: Must remove and clean daily


Products listed on this page can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer, and toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to

Preparation For Your Magnet

"Make sure the area of your car where you want to place the magnet is fairly flat or has only a mild curve, and that the entire surface is metal. If some areas are plastic or fiberglass, gaps can form, allowing wind to get under your magnetic sign and pull it off. Even new cars sometimes have unreported fiberglass repairs to metal surfaces. Therefore, it is important to test the entire surface for proper magnetic adhesion."

Why Should You Round the Corners of Magnetic Blanks?

"Our customers report that the first place that usually starts a problem for adherence of a magnetic sign to a vehicle, is the corners. Over time the corners may "flag up" creating the possibility for air and water to get underneath therefore causing the magnetic to not adhere well. Rounding the corners should help prevent this problem"


Sorry, there were no results for “{{ searchstring }}”