54" or 60" wide, 2 Mil Cast Satin White Aluminum vinyl with grey opaque, removable adhesive featuring ControlTac (pressure-activated adhesive for easy sliding and repositioning) and Comply with micro technology adhesive channel system (superior non-visible air release channel system for fast, easy, bubble-free installations) for improved slideability
Gives vehicles a high-tech, attention grabbing finish
Great conformability and lifting resistance - stretch 130% with no primer or lifting
Polyethylene-coated paper liner
3M suggests laminating with 8518, 8519, 8520, 8528, 8548G, 8549L or 8915
Caution: Always pre-test vinyl installation on vehicles. Do not install if there is any adverse or negative impact on sensors and/or other safety-related equipment on the intended vehicle.
Warning: During installation it is critical to prevent “dragging” the adhesive side of wrap vinyls over edges and flat surfaces. Abrasion caused by dragging can result in “adhesive dots” or “sanding” under the surface of the vinyl and make it appear to have many small bumps. This is usually not repairable. For more information and installation advice, please view the video below titled “Avoid Dots/Adhesive lines”.
Products listed on this page can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer, and toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov