60" wide, 3.2 Mil Carbon Fiber cast vinyl with built in protective clear coat layer and EZ Apply/air egress and RS/slideability features
No overlaminate required
Superior conformability over curved surfaces, corrugations and rivets
Easy Apply RS feature allows for faster positioning, bubble free application and long term removability
Outstanding durability and outdoor performance
Carbon Fiber colors have an expected outdoor life of 4 years with limited warranty
Clean removability up to 4 years
CAUTION: Carbon Fiber patterns have a directional characteristic in their appearance. For the best overall appearance, do not alternate between lengthwise and widthwise graphic panels.
Caution: Always pre-test vinyl installation on vehicles. Do not install if there is any adverse or negative impact on sensors and/or other safety-related equipment on the intended vehicle.
Warning: During installation it is critical to prevent “dragging” the adhesive side of wrap vinyls over edges and flat surfaces. Abrasion caused by dragging can result in “adhesive dots” or “sanding” under the surface of the vinyl and make it appear to have many small bumps. This is usually not repairable. For more information and installation advice, please view the video below titled “Avoid Dots/Adhesive lines”.
Film colors can vary slightly from roll to roll. For the most consistency, please purchase a full roll. We are unable to guarantee consistency with multiple orders of cut yardage.
The Avery Dennison warranty is for product value only and provides no protection or reimbursement for additional costs including labor or vehicle/paint damage. Please refer to the Information Sheets below.
Products listed on this page can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer, and toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov