3M™ Stripe Off Wheel 07498

  • 3M(SKIT or WHEEL)

    3M(SKIT or WHEEL)


    Email us your photos to Gallery@fellers.com


NOTE: 50 yd orders contain two 25 yd rolls

  • Solid wheel designed for removal of vinyl striping, decals and graphics
  • Use on tools with 4,000 RPM. Optimum speed is 2,000 RPM plus or minus 200
  • Wheel size is 4"x 5/8"
  • Available in a kit with both the wheel and mandrel for attaching to drill or available just in the wheel only


Most Wrap Installers Use Heat

"Whether you use a torch or a heat gun on your wraps, heat is an important part of any wrap. Heat can be used to make pressure sensitive vinyl conformable around curves, rivets, and other irregular surfaces. Post heat is also a critical step when doing vehicle wraps to help "set" the vinyl. Direct heat should especially be applied to areas where the vinyl has been stretched. Slowly move the heat source across these areas until the Mastercool Infrared Temperature Gun reads no more than 200 degrees Fahrenheit (most manufacturers recommend not heating vinyl beyond 200 degrees), then move the heat source approximately one inch every two to three seconds. This technique relaxes the stress on the vinyl caused by stretching, which will help prevent lifting and tenting. Finally, heat is often used to remove a wrap, especially in cold environments. Heat allows the vinyl to come off faster and improves the ability to remove the adhesive with the vinyl instead of leaving adhesive on the surface which would require even more labor to remove."

WARNING: Do not use heat sources near gas tanks or flammable substance


Sorry, there were no results for “{{ searchstring }}”