3M™ IJ170Cv3-10 (No Controltac)

  • 3MV3IJ170C54150



    Email us your photos to Gallery@fellers.com

    Products listed on this page can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer, and toluene, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov



NOTE: 50 yd orders contain two 25 yd rolls

  • 2 Mil Cast vinyl with grey opaque, removable adhesive featuring Comply adhesive channel system (superior non-visible air release channel system for fast, easy, bubble-free installations)
  • Great for short to long-term removable fleet and vehicle graphics, as well as interior and exterior signs
  • 10 year outdoor durability
  • Basically, 180Cv3 without Controltac.
  • V3 pressure-sensitive adhesive with non-visible air-release channels for fast, easy, bubble-free installations
  • Removable with heat and chemicals.  Removal process not covered under warranty
  • Polyethylene coated paper liner
  • 3M suggests laminating with 8518, 8519, or 8520
  • Caution:  Always pre-test vinyl installation on vehicles.  Do not install if there is any adverse or negative impact on sensors and/or other safety-related equipment on the intended vehicle
  • Print Compatibility: Solvent, Eco-Solvent, UV, Latex
  • For profiles: 3M Graphic Solutions - Color / ICC Profiles


Sorry, there were no results for “{{ searchstring }}”